Module parameters:

Scope: High-power LED constant current driver, rechargeable lithium batteries (including ferroelectric), 4V, 6V, 12V, 14V, 24V battery charging, nickel-cadmium nickel-metal hydride batteries (battery) charging, solar panels, wind generators Input voltage: 7-40V Output voltage: continuously adjustable (1.25-35V) (applied to the input voltage is higher than the output voltage applications can boost) Output Current: 8A, 10A maximum time within the (power tube temperature exceeds 65 degrees, please add cooling fan, 24V 12V 5A turn within generally be used at room temperature without a fan) Constant Range: 0.3-10A (adjustable) module over 65 degrees, please add fan. Turn lights Current: current value * (0.1), turn the lamp current and constant value linkage, such as constant value of 3A, turn the lamp current is set to a constant current of 0.1 times (0.1 x 3A = 0.3A), when the constant 2A, when adjusted to the current value, then turn the lamp current constant current of 0.1 times (0.1 x 2A = 0.2A). This version is a fixed 0.1 times (actually turn the lamp current value is probably not very accurate) is full of instructions for charging. Minimum pressure: 1V Conversion efficiency: up to about 95% (output voltage, the higher the efficiency) Operating frequency: 300KHZ Output Ripple: about the ripple 50mV (without noise) 20M bandwidth (for reference) Input 24V Output 12V 5A measured Operating temperature: Industrial grade (-40 ℃ to + 85 ℃) (please note the actual use of the power tube temperature, the temperature is too high, please enhance heat dissipation) No-load current: Typical 20mA (24V switch 12V) Load regulation: ± 1% (constant) Voltage Regulation: ± 1% Constant accuracy and temperature: the actual test, the module temperature changes from 25 degrees to 60 degrees, the change is less than 5% of the current value (current value 5A) Dynamic response speed: 5% 200uS Potentiometer adjustment direction: clockwise (increase), counterclockwise (decrease) Indicator: color indicator, charging indicator light red, fully charged light green (no load is green) Output short circuit protection: Yes, constant current (constant current setting values) Input reverse polarity protection: None, Output anti-anti-perfusion: no, for charging the battery needs additional two diodes! Connection: Terminals